Olimex A10-OLinuXino-Lime
| Olimex A10-OLinuXino-Lime | |
|---|---|
 | |
| Manufacturer | Olimex |
| Dimensions | 84mm x 60mm x 20mm |
| Release Date | December 2013 |
| Website | Product page |
| Specifications | |
| SoC | A10 @ 1Ghz |
| DRAM | 512MiB DDR3 @ 480MHz (MEM4G16D3EABG-125) |
| Power | DC 5V @ 1A |
| Features | |
| Video | HDMI (Type A - Full) |
| Audio | HDMI |
| Network | 10/100Mbps Ethernet (Realtek RTL8201CP) |
| Storage | µSD, SATA, 4GB NAND (optional) |
| USB | 2 USB2.0 Host, 1 USB2.0 OTG |
| Headers | UART, LCD/Touchscreen, LiPo Battery, 4 GPIO connectors |
The A10 Olinuxino LIME is a low-cost OSHW board that fits in the palm of your hand. This board is produced by Olimex and can be purchased for about 30€.
Identification
The board handily reads "A10-OLinuXino-Lime" on the back.
Sunxi support
Current status
Fully supported.
Manual build
You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.
U-Boot
Sunxi/Legacy U-Boot
Use the A10-OLinuXino-Lime build target.
Upstream/Mainline U-Boot
Use the A10-OLinuXino-Lime build target.
Linux Kernel
Sunxi/Legacy Kernel
Use the a10-olinuxino-lime.fex file.
Upstream/Mainline kernel
Use the sun4i-a10-olinuxino-lime.dtb device-tree binary.
Tips, Tricks, Caveats
FEL mode
The recovery button (right, under the battery connector) triggers FEL mode.
LCD modules
You can attach several Olimex LCD modules to the LCD connector (LCD_CON). You will need a 1.27mm pitch to 2.54mm 40 pin cable though.
Adding a serial port
There is a clearly marked 3 pin 2.54mm header which exposes UART0, just attach some leads according to our UART howto.
Pictures
Also known as
This type of device has no rebadges.