|Dimensions||260mm x 159mm x 13mm|
|Release Date||April 2013|
|SoC||A10 @ 1Ghz|
|DRAM||1GiB DDR3 @ 432MHz|
|Power||DC 5V @ 3A, 6500mAh 3.7V Li-Ion battery|
|LCD||1024x768 (10" 4:3)|
|Touchscreen||5-Finger capacitive (Goodix GT828)|
|Video||HDMI (Type C, mini)|
|Audio||3.5mm headphone plug, HDMI, internal stereo speakers, internal microphone|
|Network||WiFi 802.11 b/g/n (Realtek RTL8188CTV)|
|USB||1 x USB2.0 OTG|
|Camera||0.3MP (640x480) front, 2MP (1600x1200) rear|
If a device is special, then feel free to provide a terse description of what makes this device so special. But terse, no novels, no marketing blurp.
- 1 Identification
- 2 Sunxi support
- 3 Tips, Tricks, Caveats
- 4 Adding a serial port (voids warranty)
- 5 Pictures
- 6 Also known as
- 7 See also
In android, under Settings->About Tablet, you will find:
- Model Number: 1030TPC
- Build Number: 1030TPC20130111
Give a brief overview of the current status of support under sunxi here. If there is mainline support for either u-boot or kernel, mention this too, but add the extra sections below.
Add MANUFACTURER DEVICE specific sunxi ROM images here. E.g. a livesuit image or some other linux image which uses linux-sunxi code. Do not put non-sunxi images here, they should live under See also
Add MANUFACTURER DEVICE HW-pack specifics here.
Add MANUFACTURER DEVICE BSP specifics here.
- For building u-boot, use the "MANUFACTURER_DEVICE" target.
- The .fex file can be found in sunxi-boards as MANUFACTURER_DEVICE.fex
Everything else is the same as the manual build howto.
If there is mainline u-boot support, add this section.
For building mainline u-boot, use the "MANUFACTURER_DEVICE" target.Don't forget to add
[[Category:Mainline_U-Boot]]at the bottom of the page.
If there is mainline kernel support, add this section.
Use the FAMILY-CHIP-DEVICE.dtb device-tree file for the mainline kernel.Don't forget to add
[[Category:Mainline_Kernel]]at the bottom of the page.
Tips, Tricks, Caveats
Add MANUFACTURER DEVICE specific tips, tricks, Caveats and nice to have changes here.
The something button triggers FEL mode.
Device specific topic
Adding a serial port (voids warranty)
This section explains how to attach a serial port to the device. Make sure it refers to our UART howto. For a development board, you can just mention how to find the header with the pins and include a picture, and you can remove the warranty voiding warning.
If necessary, provide a short description of how to open the device. Perhaps explain how the pins can be most easily popped. If pins do need to be popped, mention the Plastic tool howto.
Locating the UART
Describe how to find the RX,TX,GND signals here, and mention the UART howto.
Also known as
List rebadged devices here.
Add some nice to have links here. This includes related devices, and external links.
Optional. Add non-sunxi images in this section.