This page needs to be properly filled according to the New Device Howto and the New Device Page guide.

Identification

Inet 10F
	{{{image}}}
Manufacturer	Inet-Tek
Dimensions	267mm x 164mm x 18mm (570g)
Release Date	2012
Specifications
SoC	A10 @ 1Ghz
DRAM	1024MiB DDR3
NAND	4GB
Power	DC 5V @ 2A, 5500mAh Li-Ion battery
Features
LCD	1024x600 (10" 10:6)
Touchscreen	5-finger capacitive ()
Video	HDMI (Type C - mini)
Audio	3.5mm headphone plug, HDMI, internal speaker, internal microphone
Network	WiFi 802.11 b/g/n (Realtek RTL8188EUS)
Storage	µSD
USB	1 USB2.0 Host, 1 USB2.0 OTG
Camera	0.3MP (640x480) front, 2.0MP back
Other	Accelerometer (Manufacturer device FIXME), reset button
Headers	UART

On the back of the device, the following is printed:

POINT OF VIEW MOBII icon
TAB-PROTAB25XXL

The PCB has the following silkscreened on it:

INET-10F-REV03
Zeng-gc 2012-10-26

In android, under Settings->About Tablet, you will find:

Manual build

You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.

Use the MANUFACTURER_DEVICE build target. --> TODO but inet1 uboot works for now

Use the FAMILY-CHIP-DEVICE.dtb device-tree binary.

Add MANUFACTURER DEVICE specific tips, tricks, Caveats and nice to have changes here.

The something button triggers FEL mode.

see inet1, they contact pads are not marked rx/tx but are there (3 contact pads )

By removing the two screws on the connector side, the device is trivially opened.

There are some UART pads next to the wire going to the wifi antenna, all you need to do is solder on some wires according to our UART howto.

Take some pictures of your device, upload them, and add them here. DO NOT UPLOAD PICTURES WHICH YOU PLUCKED OFF THE INTERNET.

List rebadged devices here.