Icoo d70gt

From linux-sunxi.org
Jump to navigation Jump to search
Icoo d70gt
Device front.jpg
Manufacturer Icoo
Dimensions 193mm x 120mm x 12mm
Release Date April 2012
Website Product Page
SoC A10 @ 1Ghz
DRAM 1GiB DDR3 @ xxxMHz
NAND 4/8/16GB
Power DC 5V @ ?A, 3500mAh 3.7V Li-Ion battery
LCD 1024x600 (7" X:Y)
Touchscreen 5-finger capacitive (Goodix GT801)
Video HDMI (Type C - mini)
Audio 3.5mm headphone plug, HDMI, internal speaker, internal microphone
Network WiFi 802.11 b/g/n (Realtek RTL8188CUS)
Storage µSD
Camera 1.3MP (1280x1024) front
Other Accelerometer (Freescale MMA7660)

This page needs to be properly filled according to the New Device Howto and the New Device Page guide.


In android, under Settings->About Tablet, you will find:

  • Model Number: DEVICE
  • Build Number: SOC_BOARD_DEVICE_*.*

Sunxi support

Current status

No patches have been submitted and the board is not supported.




Manual build

  • For building u-boot, use the "MANUFACTURER_DEVICE" target.
  • The .fex file can be found in sunxi-boards as MANUFACTURER_DEVICE.fex

Everything else is the same as the manual build howto.

Tips, Tricks, Caveats

FEL mode

The something button triggers FEL mode.

Adding a serial port (voids warranty)


Device disassembly

The mainboard and battery are tied to the back cover, so be careful when opening this device . Use your [[Plastic_tool|plastic tool] to gently push the edge of the bottom cover outwards, you should soon hear clips releasing.

Locating the UART

Describe how to find the RX,TX,GND signals here, and mention the UART howto.


Take some pictures of your device, upload them, and add them here.

Also known as

The board was developed by Shenzhen Sochips Technology limited, and is called the Sochips SC3061. No other references turn up on the internet but the Icoo D70GT.

See also