CherryPi PC V7

From linux-sunxi.org
Jump to navigation Jump to search
CherryPi PC V7
CherryPi PC V7 Top.jpeg
Manufacturer Shenzhen LC Technology
Dimensions 85mm x 56mm
Release Date January 2021
Website LcTech Pi H3 V7 Product Page
Specifications
SoC H3 @ 1.2Ghz
DRAM 1GiB DDR3 (SK hynix H5TQ4G63CFR-RDC × 2)
NAND 8GB (Samsung KLM8G1GETF-B041)
Power via 5V Type-C USB or via 5V microB OTG
Features
Video HDMI (Type A - full), CVBS
Audio 3.5mm headphone plug, HDMI, on-board microphone
Network WiFi 802.11 b/g/n (Realtek RTL8189FTV), 10/100 Ethernet
Storage µSD, eMMC
USB 2 x USB2.0 Host, 1 x USB2.0 OTG
Camera MIPI CSI

This page needs to be properly filled according to the New Device Howto and the New Device Page guide.

Identification

CherryPi PC V7 is a development board by Shenzhen LC Technology Co., Ltd. based on Allwinner H3 with a standard Raspberry Pi 3/4 board size. At some point name was changed to Lctech Pi H3 V7

The PCB has the following silkscreened on the bottom:

CherryPi-PC V7.3
www.lctech-inc.com

In android, under Settings->About Tablet, you will find:

  • Model Number: dolphin
  • Build Number: dolphin_fvd_p2-eng 4.4.2 KOT49H 20200906 test-keys

Stock firmware

The board comes with a preinstalled Android 4.4.2 firmware based on v3.4.39 Linux kernel. U-Boot is 2011.90-rc1 Allwinner v1.1.0

Manual build

You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.

U-Boot

Mainline U-Boot

Use the orangepi_plus build target. The U-Boot repository and toolchain is described in the Mainline U-Boot howto.

The H3 boards can boot from SD cards, eMMC, NAND or SPI NOR flash (if available), and via FEL using the OTG USB port. In U-Boot, loading the kernel is also supported from USB or ethernet (netboot). HDMI support in U-Boot is still WIP.

Linux Kernel

Mainline kernel

Board appears to be compatible with images built for the Xunlong_Orange_Pi_Plus so use the sun8i-h3-orangepi-plus.dtb device-tree binary.

Locating the UART

Standard on-board GND/TX/RX 3-pin UART pin header (3.3V) located between HDMI and OTG ports, refer to the UART howto for more information.

Pictures

Also known as

Lctech Pi H3 V7

See also

CNX-Software article LinuxGizmos article