Biqu CB1
| Biqu CB1 | |
|---|---|
| Manufacturer | [1] |
| Dimensions | 40mm x 55mm |
| Release Date | 2022 |
| Website | [2] |
| Specifications | |
| SoC | H616 @ 1.512 Ghz |
| DRAM | 1GiB DDR3 @ 720 MHz (2x Kingston D2516ECMDXGJD) |
| Features | |
| Video | 2x HDMI (Micro) |
| Audio | HDMI |
| Network | WiFi 802.11 b/g/n (Manufacturer device), 10/100Mbps Ethernet (Manufacturer device) |
| Storage | µSD |
| USB | 2/3/4 USB2.0 Host |
| Headers | UART, JTAG, LCD, VGA, ... |
Biqu CB1 is a H616 based board in Raspi Compute Module form factor, requires an extension board to drive(power, GPIO, ports .etc).
This page needs to be properly filled according to the New Device Howto and the New Device Page guide.
If a device is special, then feel free to provide a terse description of what makes this device so special. But terse, no novels, no marketing blurb.
Identification
The board has silkscreened: BigTreeTech_CB1_VX.X
Sunxi support
Current status
Board boots and works with downstream 5.16 kernel provided by Biqu.
Images
https://github.com/bigtreetech/CB1/releases
Manual build
You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.
U-Boot
Use the h616_defconfig build target.
Mainline U-Boot
WIP
Linux Kernel
Mainline kernel
WIP
Tips, Tricks, Caveats
Could not yet figure out how to boot the board in FEL mode
UART
Adding a serial port (voids warranty)
Adding UART is very simple. All pins are already on the board. Just need to be soldered to. They are located on top of the board near the H616 SoC