|Dimensions||182mm x 121mm x 7mm|
|Release Date||August 2013|
|Website||Missing Product Page|
|SoC||A13 @ 1Ghz|
|DRAM||512MiB DDR3 @ 360MHz (Spectek PEB15-15E)|
|Power||DC 5V @ 2A, 3000mAh 3.7V Li-Ion battery|
|LCD||800x480 (7" 16:9)|
|Touchscreen||5-finger capacitive (Silead GSL1680)|
|Audio||3.5mm headphone plug, internal speaker, internal microphone|
|Network||WiFi 802.11 b/g/n (Realtek RTL8188ETV)|
|USB||1 USB2.0 OTG|
|Camera||640x480 (VGA) front-facing, Optional rear-facing camera|
This page needs to be properly filled according to the New Device Howto and the New Device Page guide.
A standard A13 based, Q8 style device.
The PCB has the following silkscreened on it:
AL-A13Q8-V8_5 REV:8.5 2013.08.07
In android, under Settings->About Tablet, you will find:
- Model Number: DEVICE
- Build Number: SOC_BOARD_DEVICE_*.*
Give a brief overview of the current status of support under sunxi here. If there is mainline support for either U-Boot or kernel, mention this too, but add the extra sections below.
- For building U-Boot, use the MANUFACTURER_DEVICE target.
- The .fex file can be found in sunxi-boards as MANUFACTURER_DEVICE.fex
Everything else is the same as the manual build howto.
Tips, Tricks, Caveats
The Volume- button triggers FEL mode.
Adding a serial port (voids warranty)
There are no UART pads available on this device. You will have to use the MicroSD Breakout adapter.
See the Q8 tablet format disassembly page.
Locating the UART
Pins 151 and 152 of the TQFP do not seem to be wired up. You might get away with attaching a very very thin wire to it, but that requires some very creative soldering.
Take some pictures of your device, upload them, and add them here. DO NOT UPLOAD PICTURES WHICH YOU PLUCKED OFF THE INTERNET.