Rongpin RP-H6B
| Rongpin RP-H6B | |
|---|---|
 | |
| Manufacturer | Shenzhen Rongpin Electronic Technology Co., Ltd. |
| Dimensions | 160mm x 90mm x 17mm |
| Release Date | April 2018 |
| Website | Device Product Page |
| Specifications | |
| SoC | H6 @ 1.5 Ghz |
| DRAM | 1GiB LPDDR3 @ xxxMHz |
| NAND | 8GiB eMMC |
| Power | DC 12V @ xxxA (Max36W) |
| Features | |
| Video | HDMI 2.0a, CVBS OUT |
| Audio | HDMI, PHONE OUT |
| Network | 10/100Mbps Ethernet @ RJ45 |
| Storage | micro SD |
| USB | 4 HOST USB 2.0, 1 HOST USB 3.0 |
| Other | UART0(Debug) |
This page needs to be properly filled according to the New Device Howto and the New Device Page guide.
Rongpin RP-H6B is H6 based development board produced by Rongpin.
Identification
On the back of the device, the following is printed:
RP-H6B
Sunxi support
Current status
Give a brief overview of the current status of support under sunxi here.
Images
Optional. Add MANUFACTURER DEVICE specific sunxi ROM images here. E.g. a livesuit image or some other linux image which uses linux-sunxi code. Do not put non-sunxi images here, they should live under See also. If no sunxi based images are available, this section can be removed.
HW-Pack
Optional. Add MANUFACTURER DEVICE sunxi HW-pack specifics here. When empty, this section can be removed.
BSP
Optional. Add MANUFACTURER DEVICE sunxi BSP specifics here. When empty, this section can be removed.
Manual build
You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.
U-Boot
Sunxi/Legacy U-Boot
Use the MANUFACTURER_DEVICE build target.
Mainline U-Boot
Use the MANUFACTURER_DEVICE build target.
Linux Kernel
Sunxi/Legacy Kernel
Use the MANUFACTURER_DEVICE.fex file.
Mainline kernel
Use the FAMILY-CHIP-DEVICE.dtb device-tree binary.
Tips, Tricks, Caveats
Add MANUFACTURER DEVICE specific tips, tricks, Caveats and nice to have changes here.
FEL mode
The something button triggers FEL mode.
Device specific topic
If there are no further device specific topics to add, remove these sections.
...
Adding a serial port (voids warranty)
This section explains how to attach a serial port to the device. Make sure it refers to our UART howto. For a development board, you can just mention how to find the header with the pins and include a picture, and you can remove the warranty voiding warning.
Locating the UART
Describe how to find the RX,TX,GND signals here, and mention the UART howto.
Pictures
Take some pictures of your device, upload them, and add them here. DO NOT UPLOAD PICTURES WHICH YOU PLUCKED OFF THE INTERNET.
Also known as
List rebadged devices here.
See also
File:RP-H6C-20180316 Schematics.pdf File:RP-H6B-20180423 Schematics.pdf
Manufacturer images
Optional. Add non-sunxi images in this section.