Anbernic RG35XX H
| Anbernic RG35XX H | |
|---|---|
 | |
| Manufacturer | Anbernic |
| Dimensions | Length 18.7cm;Width 9.3cm;Height 3cm |
| Release Date | December 2023 |
| Website | Device Page |
| Specifications | |
| SoC | H700 @ 1.5Ghz |
| DRAM | 1GiB LPDDR4 @ 672 MHz |
| Power | DC 5V @ 3A, 3700mAh 3.7V Li-Ion battery |
| Features | |
| LCD | 640x480 (3.5" 4:3) |
| Video | mini HDMI |
| Audio | 3.5mm headphone plug, HDMI, SPDIF, internal stereo speakers |
| Network | WiFi 802.11 b/g/n + BT 4.2 |
| Storage | 2 x µSD |
| USB | 1 x USB2.0 Type-C OTG/power, 1 x USB2.0 Type-C host |
| Headers | UART |
This page needs to be properly filled according to the New Device Howto and the New Device Page guide.
Handheld gaming device built around an Allwinner H700 CPU. The device internals are basically the same as the RG35XX Plus
Identification
On the back of the device, the following is printed:
ANBERNIC Model No. RG35XX H
The PCB has the following silkscreened on it:
RG35XX H_V3.0 2023-12-14
Sunxi support
Current status
Mainline support is work in progress. See the RG35XX status for updates.
Manual build
You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.
Mainline U-Boot
Use the MANUFACTURER_DEVICE build target.
Mainline Linux Kernel
Use the FAMILY-CHIP-DEVICE.dtb device-tree binary.
Tips, Tricks, Caveats
Add MANUFACTURER DEVICE specific tips, tricks, Caveats and nice to have changes here.
FEL mode
Booting with a USB-C cable connected to the USB-OTG port (DC/OTG at top of the device) without an SD card inserted triggers FEL mode.
Adding a serial port (voids warranty)
The UART header is located between the left SDCARD and left speaker UART howto
Device disassembly
Remove the four Torx T6 screws from the rear case. There's a small gap between the back and the rest of the case, just use a pick to open it up. The L1/R1 and L2/R2 buttons may fall when you open the case, but they are simple to reinsert and don't have any springs.
Locating the UART
The UART pins are GND, TX, RX, GND.
Pictures
See also
See the RG35XX Plus page.
Manufacturer images
Optional. Add non-sunxi images in this section.