Yonnet Interra-3
| Yonnet Interra-3 | |
|---|---|
 | |
| Manufacturer | YONNET |
| Dimensions | '155mm' x '1.6mm' x '80mm' |
| Release Date | May 2014 |
| Website | Device Product Page |
| Specifications | |
| SoC | A20 @ 1Ghz |
| DRAM | 1GiB/2GiB DDR3 @ 456MHz |
| eMMC | 8Gb SANDISK SDIN7DU2-8G |
| NAND | - |
| Power | DC 12V @ 2A, 3000mAh 3.7V Li-Ion battery |
| Features | |
| LCD | 1280x800 (10.1" 16:10) |
| Touchscreen | 5-finger capacitive/resistive (Manufacturer device FIXME) |
| Video | HDMI, |
| Audio | PAM8620 HP to SPK amplifier |
| Network | 100Mbps Ethernet |
| Storage | µSD, SATA |
| USB | 2 USB2.0 Host, 1 USB2.0 OTG |
| Camera | 5MP (1280x720p) rear |
| Other | none |
| Headers | UART, LCD, ... |
This page needs to be properly filled according to the New Device Howto and the New Device Page guide.
Interra-3 is an A20 based Smart Home automation board. It doesn't include any NAND, but instead has an eMMC.
Identification
Current PCB version is 3.0, under mass production..
Sunxi support
Current status
Board is running sunxi uboot and sunxi kernel 3.4.79, with debian wheezy rootfs.
Images
This is a proprietary product, therefore its images can not be published here :(
HW-Pack
Does not exist. The board runs Android 4.2.2 and sunxi kernel. A working linux system can be built easily similar to any other A20 based device.
BSP
Does not exists.
Manual build
- For building u-boot, use the "Interra-3" target.
- The .fex file can be found in sunxi-boards as interra-3.fex
Everything else is the same as the manual build howto.
Tips, Tricks, Caveats
The board has two buttons, one is RESET and the other is RECOVERY.
FEL mode
In order to enter Recovery mode, either press RECOVERY button, or use fel-sdboot binary
Adding a serial port (voids warranty)
Please see below.
Locating the UART
The board has 3.3V TTL UART DEBUG port on it directly visible ( and written ) on the PCB silkscreen.
Pictures
Product's images can not be published at the moment :(
Also known as
Interra-3
See also
None...