X-View Proton Tab 2
| X-View Proton Tab 2 | |
|---|---|
 | |
| Manufacturer | X-View |
| Dimensions | 13mm x 80mm x 123mm |
| Release Date | September, 2013 |
| Website | Proton Tab 2 |
| Specifications | |
| SoC | A13 @ 1.1Ghz |
| DRAM | 512MiB DDR3 @ MHz |
| NAND | 4/8GB |
| Power | DC 5V @ 1A, 1400mAh 3.7V Li-Ion battery |
| Features | |
| LCD | 480x272 (4.3" 16:9) |
| Touchscreen | 5-finger capacitive (Sitronix ST1530-N40) |
| Video | none |
| Audio | 3.5mm headphone plug, internal speaker, internal microphone |
| Network | WiFi 802.11 b/g/n (Realtek RTL8188ETV) |
| Storage | µSD |
| USB | 1 USB2.0 Host, 1 USB2.0 OTG |
| Camera | 3MP (640x480) front |
| Other | Accelerometer (Manufacturer device), |
| Headers | UART, LCD |
This page needs to be properly filled according to the New Device Howto and the New Device Page guide.
Identification
On the back of the device, the following is printed:
X-View
The PCB has the following silkscreened on the front side:
M434 V4.1.0 KF006-MAINBOARD-V4.1.0 2012/08/11
On the back side:
3213 F-M E351308 94V-0
In android, under Settings->About Tablet, you will find:
- Model Number: Tablet 434
- Build Number: PROTON TAB 2 20130903
Sunxi support
Current status
Give a brief overview of the current status of support under sunxi here.
Images
Optional. Add MANUFACTURER DEVICE specific sunxi ROM images here. E.g. a livesuit image or some other linux image which uses linux-sunxi code. Do not put non-sunxi images here, they should live under See also. If no sunxi based images are available, this section can be removed.
HW-Pack
Optional. Add MANUFACTURER DEVICE sunxi HW-pack specifics here. When empty, this section can be removed.
BSP
Optional. Add MANUFACTURER DEVICE sunxi BSP specifics here. When empty, this section can be removed.
Manual build
You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.
U-Boot
Sunxi/Legacy U-Boot
Only useful for A10/A10s/A13 and A20 based devices. Remove this section otherwise.
Use the MANUFACTURER_DEVICE build target.
Mainline U-Boot
Use the MANUFACTURER_DEVICE build target.
Linux Kernel
Sunxi/Legacy Kernel
Only useful for A10/A10s/A13 and A20 based devices. Remove this section otherwise.
Use the MANUFACTURER_DEVICE.fex file.
Mainline kernel
Use the FAMILY-CHIP-DEVICE.dtb device-tree binary.
FEL mode
The Home or Volume + buttons trigger FEL mode.
Adding a serial port (voids warranty)
Luckily this device has easy and exposed pads to solder three wires for a UART interface. Refer to UART howto for more information.
Device disassembly
The back cover is the first part to come out. Refer to Plastic tool howto for more information on how to open the device.
Locating the UART
The three pads are located right above the nand flash. Removing the battery or softening the adhesive is recommended to avoid touching it with the soldering iron. For more information refer to UART howto.
