HiVision PWS700YA
| HiVision PWS700YA | |
|---|---|
 | |
| Manufacturer | HiVision |
| Dimensions | 185mm x 123mm x heightmm (265g) |
| Release Date | August 2012 |
| Website | Defunct Product Page |
| Specifications | |
| SoC | A13 @ 1Ghz |
| DRAM | 512MiB DDR3 @ xxxMHz |
| NAND | 4GB |
| Power | DC 5V @ 1.5A, 2800mAh 3.7V Li-Ion battery |
| Features | |
| LCD | 640x480 (7" 16:9) |
| Touchscreen | X-finger capacitive/resistive (TODO: Manufacturer device) |
| Audio | 3.5mm headphone plug, internal speaker, internal microphone |
| Network | WiFi 802.11 b/g/n (Realtek RTL8188CTV) |
| Storage | µSD |
| USB | 1 USB2.0 OTG |
| Camera | 0.3MP (640x480) front |
| Other | Accelerometer ( Domintech DMARD06) |
| Headers | UART |
This page needs to be properly filled according to the New Device Howto and the New Device Page guide.
Identification
Find out the strings as reported under settings.
In android, under Settings->About Tablet, you will find:
- Model Number: DEVICE
- Build Number: SOC_BOARD_DEVICE_*.*
The following was acquired differently:
- Name in build.prop: PWS700YA
- Brand in build.prop: HWX
- Product name: nuclear_708h9
- Device name: nuclear-708h9
- Board name: nuclear
Sunxi support
Current status
No patches have been submitted, so no support is available.
Images
HW-Pack
BSP
Manual build
- For building u-boot, use the "MANUFACTURER_DEVICE" target.
- The .fex file can be found in sunxi-boards as MANUFACTURER_DEVICE.fex
Everything else is the same as the manual build howto.
Tips, Tricks, Caveats
Add MANUFACTURER DEVICE specific tips, tricks, Caveats and nice to have changes here.
FEL mode
The something button triggers FEL mode.
HDMI
Even though a HDMI connector has been soldered onto the board, the A13 does not natively support HDMI, and the connector does not seem to be functional. Perhaps this connector was just added to suit this popular case format?
Adding a serial port (voids warranty)
Device disassembly
If necessary, provide a short description of how to open the device. Perhaps explain how the pins can be most easily popped.
Remove the small screws on each edge of the connectors side, then unclip the backplate from the LCD housing by inserting something thin in the gap between them.
Locating the UART
Describe how to find the RX,TX,GND signals here, and mention the UART howto.
There seems to be a few pads right next to the SoC. One pair of them is bound to be RX/TX.
Pictures
Take some pictures of your device, upload them, and add them here.
Also known as
- Gonomad PWS700YA
See also
Add some nice to have links here. This includes related devices, and external links.