LicheePi One
| LicheePi One | |
|---|---|
 | |
| Manufacturer | Zepan |
| Dimensions | 72mm x 54mm |
| Release Date | Nov. 2016 |
| Website | [1] |
| Specifications | |
| SoC | A13 @ 1.0Ghz |
| DRAM | 256MiB/512MiB DDR3 @ 408MHz |
| Power | DC 5V via USB jack, USB OTG power |
| Features | |
| LCD | optional |
| Touchscreen | optional |
| Video | TV Composite (optional) |
| Audio | 3.5mm headphone plug with Mic (default) / TV (optional) |
| Network | WiFi 802.11 b/g/n (RTL8723BU) (optional) |
| Storage | µSD * 2 |
| USB | 1 USB2.0 HOST, 1 USB2.0 OTG |
| Camera | optional |
| Headers | 2 Custom GPIO Headers, CSI, RGB LCD |
Identification
The PCB has the following silkscreened on it:
Lichee Pi
Sunxi support
Current status
Not support, but there's officiallly supported FEX and defconfig for it at the git repo.
Manual build
You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.
U-Boot
Sunxi/Legacy U-Boot
Use the defconfig here
Mainline U-Boot
Not supported yet.
Linux Kernel
Sunxi/Legacy Kernel
Use the official fex file.
Mainline kernel
Use the sun5i-a13-licheepi-one.dtsb device-tree tree binary.
Tips, Tricks, Caveats
FEL mode
Just removing all SD Cards triggers FEL mode.
The HOME key also works as FEL key.
About the two Micro-USB ports
The port tagged J5 is the real USB OTG port.
The port tagged J10 is only a jack for DCIN in the Micro USB form.
Adding a serial port
The picture is the UART connection, with the green cable as the board's TX (cable's RX), white cable as the board's RX (cable's TX), and the black cable as GND.
The USB2TTL cable used in the picture is the cable described in Cubieboard/TTL.
Locating the UART
The debugging UART is the UART1, located at the top-right corner, silked with RX and TX.
GND is available at the bottom-right corner.
Both needs soldering to work.
