AL-AX3-Q8
| AL-AX3-Q8 | |
|---|---|
 | |
| Manufacturer | Along |
| Dimensions | Q8 |
| Release Date | June 2015 |
| Website | Device Product Page |
| Specifications | |
| SoC | A33 @ XGhz |
| DRAM | 512MiB DDR3 @ xxxMHz |
| NAND | 4GB |
| Power | DC 5V @ 2A, ????mAh 3.7V Li-Ion battery |
| Features | |
| LCD | Q8 |
| Touchscreen | 5-finger capacitive ( GSL1680) |
| Video | none |
| Audio | 3.5mm headphone plug, internal speaker, internal microphone |
| Network | WiFi 802.11 b/g/n (Manufacturer esp8089) |
| Storage | µSD |
| USB | 1 USB2.0 OTG |
| Camera | ??.?MP (????x????) front, ??.?MP (????x????) rear |
| Other | Accelerometer (Manufacturer MMA8653FC) |
| Headers | UART |
This page needs to be properly filled according to the New Device Howto and the New Device Page guide.
If a device is special, then feel free to provide a terse description of what makes this device so special. But terse, no novels, no marketing blurb. This device has eMMC pads under NAND chip
Identification
This section explains how to most easily identify your device. For a development board, explain the name(s) printed on the board. For an android device, find out the strings as reported under settings.
The PCB has the following silkscreened on it:
AL-Ax3-Q8-V1.1 2015-01-21
Sunxi support
Current status
Give a brief overview of the current status of support under sunxi here. Works fine with q8_a33_tablet_800x480_defconfig
Manual build
You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.
Mainline U-Boot
Use the MANUFACTURER_DEVICE build target.
Mainline kernel
Use the sun8i-a33-q8-tablet.dtb device-tree binary.
FEL mode
When tablet is off, hold both volume buttons and power button, release power button and start pressing it for 3 seconds
...
Adding a serial port (voids warranty)
This section explains how to attach a serial port to the device. Make sure it refers to our UART howto. For a development board, you can just mention how to find the header with the pins and include a picture, and you can remove the warranty voiding warning.
2 UART pads are just below A33 SoC package.
Device disassembly
If necessary, provide a short description of how to open the device. Perhaps explain how the pins can be most easily popped. If pins do need to be popped, mention the Plastic tool howto.
Standard Q8 disassembly applies
Locating the UART
Describe how to find the RX,TX,GND signals here, and mention the UART howto. 2 UART pads are just below A33 SoC package.
Pictures
Take some pictures of your device, upload them, and add them here. DO NOT UPLOAD PICTURES WHICH YOU PLUCKED OFF THE INTERNET.
Also known as
List rebadged devices here.
- AL-AX3-Q8-V6051-V2.0
- AL-AX3-Q8-V1.1
- MID721QC
See also
Add some nice to have links here. This includes related devices, and external links. High resolution photos of device internals
Manufacturer images
Optional. Add non-sunxi images in this section.