Search results

...eeds to be properly filled according to the [[New_Device_howto |New Device Howto]] and the [[New_Device_page|New Device Page guide]].}} == Manual build ==

[[File:A80 Pcduino8 Board Front.jpg|thumbnail]] | soc = [[A80]] @ 1008Mhz

| soc = [[A80]] @ 1008Mhz The Cubieboard4 Board is a development board for the Allwinner [[A80]] SoC.

| soc = [[A80]] @ 1008Mhz The A80 Optimus Board is a official development board for the Allwinner [[A80]] SoC, targeting both developers and consumers.

Android packages, buildroot, build scripts and a matching Linaro toolchain. This howto assumes you have such an SDK. This document is based on the A23 and

You should be running through this howto as part of our [[Manual build howto]]. It guides you through toolchain, u-boot and rootfs steps as well. ...old relevant .config, e.g. if you installed a late debian, and now want to build the kernel, you can copy it in and run <code>make ARCH=arm oldconfig</code>

| soc = [[A80]]: 4 x ARM Cortex-A15 cores @ 1.8 GHz + 4 x ARM Cortex-A7 cores @ 1.2 GHz. ...eeds to be properly filled according to the [[New_Device_howto |New Device Howto]] and the [[New_Device_page|New Device Page guide]].}}

This page describes how to build and use [http://www.denx.de/wiki/U-Boot upstream U-Boot] for 32bit (armv7/a ! style="text-align: left;" |[[A80]]

...ges compared to the build steps in [[Manual_build_howto | the manual build howto]], and these changes are explained on this wiki page. ...device needs to be switched into FEL mode. Please refer to the [[FEL | FEL howto]] for information on how to boot to FEL mode. Device pages should mention t